1678 S River Rd, Des Plaines, IL 60018

Call Us: (847) 558-6697
Email Us: art@ancmechanical.com

Clean and Service


This is the steps taken in the process of Clean and Service call:

Click here to schedule your clean and service appointment.

Precision tune-up and professional cleaning of AC unit includes the following 20 operations:

  1. Blower Motor – measure amperage and voltage for proper operation
  2. Thermostat – test for proper operation, calibrate and level
  3. Clean existing air filter (Electronic air cleaner) or replace
  4. Bearing – inspect for wear and lubricate
  5. Inspect indoor coil
  6. Condensate Drain – flush and treat with anti-algae
  7. Inspect Condenser Coil
  8. Refrigerant – monitor operating pressures
  9. Safety Devices – inspect for proper operation
  10. Electrical Disconnect Box – inspect for proper rating and safe installation
  11. Electrical Wiring – inspect and tighten connections
  12. Test/inspect contactors for burned, pitted contacts
  13. Inspect electrical for exposed wiring
  14. Inspect and test capacitors
  15. Inspect fan blade
  16. Clean condenser coil and remove debris
  17. Inspect service valves for proper operation
  18. Measure Supply/Return temperature differential
  19. Inspect duct work for energy loss
  20. Compressor – monitor, measure amperage and volt draw and wiring connections

 

Precision tune-up and professional cleaning for Heating season includes the following 20 operations:

  1. Carbon Monoxide – test air flow duct system for dangerous carbon monoxide
  2. Thermostat – test for proper operation, calibrate and level
  3. Inspect for combustible material around furnace
  4. Ignition System – test for safe and proper operation
  5. Exhaust System – test for proper venting
  6. Measure Supply/Return temperature differential
  7. Safety & Control Circuits – test for proper operation
  8. Inspect and adjust fan belt tension (if applicable)
  9. Clean existing air filter
  10. Lubricate and clean blower motor air vents
  11. Furnace Burner – clean and inspect (brush and vacuum)
  12. Heat Exchangers – clean and inspect (brush and vacuum)
  13. Clean furnace exterior
  14. Inspection of heat exchangers for dangerous cracks and wear
  15. Gas Pressure – measure and adjust for peak efficiency
  16. Lubricate all moving parts per manufacture
  17. Blower Motor – measure amperage and voltage for proper operation
  18. Electrical Wiring – inspect and tighten connections
  19. Combustion Vents – clean and inspect (upper and lower)
  20. Infrared camera inspection of furnace heat exchanger
  21. Natural Gas – check for leaks